Main functions: The machine can provide steam, fumigation, water care and remote infrared energy and spectrum light etc. Therefore, it is a real multiple functional health care equipment, it is also necessary for rich families, it is a real family beautician
3. Operating instruction to Computer controlled panel(with Tone function):
Connect the pipes ( Hot and Cold water valves must be installed ). Then insert the plug with electricity loss protect into the outside socket (220V, 15A), press On to connect power. Then open the coming water valve, and connect the pipes to the drains. Turn on the computer-controlled panel, the screen displays the set time and current interior temperature.
Temperature: Press Up or Down to set the temperature. Normally, it is set at 40～450C.
Time: Press Up or Down to choose. Usually, the duration is from 20～30 minutes.
Steam: After set time and temperature, press this button, steamer begins to work. Press again, it will stop.
Volume (+/-): Use ADD or MINUS to fix.
MP3: Press this button,Begin to works; press again, turn off.
MP3/VOL: Press this key, set MP3 or VOL;.
Remote infrared: Press this button, the remote infrared machine starts to work; press again, it will stop.
i. Sterilize: After finish and clean, press this button, it begins to sterilize,
normally, for 20 minutes. Press again, it will close.
◆There shall be a strict check on the water entrance system, the steam pipeline, power box and the electric line. The machine can only be used without water shortage.
The main steam engine and the power box can not be installed in a bathroom, and the main steam engine shall be installed vertically as shown by an arrow on its outer cover.
The inner diameter of the steam pipeline shall be above 15mm. Do not fix a valve at the steam exit.
Do not connect this machine with other electric appliances not recommended by the firm, and do not take apart the hermetic sealed lines or the line full of electricity from the power box or pull in or out the plug-in units.
◆A drainage pipeline shall be fixed to drain away the water from the main steam engine, and it’s better to add a water filter before the water entrance to increase more service life .
◆In hard watered area, the steam generator shall be regularly descaled. Usually, it shall be checked every three months and descaled. The following ways of descaling are permissible: use citric acid about 5~10 grams to be diluted with warm water about 1.4 liter, take apart the pipeline with the steam exit of the main engine, put citric acid into the main engine from the steam exit, then get the steam pipeline connected, stay over 60 minutes heat the engine for 30 minutes and then stop to get the left water in the machine out.
The line from the power box shall be plugged according to the digit capacity and the size. Do not make any short circuit.
The steam engine shall be installed by the qualified and authorized technical persons.